Stop Fighting With Your Glass Bending Furnace
Let’s be honest: standard infrared lamps are great until you’re working with a furnace that wasn’t built to “standard” specs. When space is tight, trying to cram an off-the-shelf heating element into a non-standard oven is a nightmare. You end up with frustrating cold spots, or worse, you’re staring at a dangerous electrical short because the lamp just doesn’t fit. We fix that by building lamps that actually match your layout. No compromises. Getting the fit right If your furnace footprint is cramped, you can’t just “make it work” with a generic tube. That’s why we build to your exact millimeter. It means you can tuck heating elements into those awkward corners or pack them closer together without hitting the chassis. We can also tweak the wattage and heat density based on the length. If you need a lot of power in a tiny space, we can crank up the density—just make sure your cooling blowers are up to the task so things don’t get too hot at the ends. Heat where you actually need it Custom shapes aren’t just about fitting into a box. It’s about the glass. We all know that uneven heat leads to internal stress and shattered glass. It’s a heartbreaking way to lose a piece. We design the lamp geometry to follow the curve of your bending jig or wrap around the glass profile. The heat goes exactly where it belongs. That means less waste and faster cycle times. No more “making it fit” The best part? These are drop-in replacements. Whether you need a specific end-cap or wiring that actually plugs into your existing panel, we figure it all out before we start building. You get a heater that fits the first time. No grinding down furnace frames, no sketchy makeshift brackets, and no headaches. Just a setup that works.